Advertisement
Switching The Display
Switching The Digital Display
Press switch to change
Water Temp
the multi-digital display
in operation
Water Temperature Reading the Display
- 35– - 1 °C
The first place on the
The third place from the
-
left shows "
" (minus).
left shows "
Motor RPM Reading the Display
0 – 9900rpm
over 10000rpm
Illumination color settings
1
POWER
+
READY Mode
After the meter off,
Engine start during
pressing the switch
Illumination brightness settings
1
Press
the switch
for 6 seconds
Holding downs the switch
in operation
5
Release
the switch
after setting is done
Troubleshooting
Trouble
Does not work with Engine start.
Upon starting up, the unit will not start in the
newly changed display.
Before the opening demo starts the needle briefly
moves.
The displayed values are different from the standard
meter.
• Our products have already been recognized as our Industrial Property or are in the process of receiving Industrial Property status.
(Note)
• We plan in the near future to take all possible legal measures to protect against unfair competition from look-alike products using similar designs, regulating characteristics,
circuitry and circuitry layout.
• We strictly prohibit the unlicensed use of the PIVOT trademark and the unauthorized use of PIVOT User's Manual.
4
Voltage
Motor RPM
0–99 °C
100–150 °C
c
Numerical Value Only.
" (Celsius).
(display unit : 100rpm)
(decimal point
is lightning)
2
Display the current
illumination color setting
(Initial value)
Release the switch
after displayed
the current setting
2
Display a peak value after
3 seconds and the current
brightness after 6 seconds
(Initial value)
6
Back to normal display with
no operation for 5 seconds
Setting Completed
Poor connection of Gauge cable ,
6-pin Connector or OBD Connector wires.
The unit has been installed into an incompatible
car model.
Because after changing displays, if the car's engine is turned off within 3 seconds, the new setting will
not be stored, make sure to wait at least 3 seconds before turning the engine off.
This is due to a special characteristic of the meter and is not a malfunction.
Due to the ECU information received, the displayed values on this product may differ from those of
standard or other meters.
Display and Reset the Peak Value
Real-time Display
(Lighting)
(Lighting)
(Lighting)
Only the peak value on display will be reset. This will return to the Real-time Display
for the currently displayed mode.
• Peak readings are reset when the power is turned OFF.
• For RPM and Water Temperature the high will be shown and for Voltage the low will be
displayed.
• For Motor RPM the high Peak Value will be shown on the Digital Display.
3
Press the
switch to change
the color
c-1
c-2
[
= White,
= Blue ]
Each pressing will change the color
Adjustment in case of anxious about reflected illumination of door mirror
or something
3
Release the switch
after displayed
the current setting
Possible Causes
PIVOT CORPORATION
87-3, Shimookada Okada, Matsumoto-shi, Nagano, 390-0313 JAPAN
Peak Value Display
3
for
Seconds
Press
Switch
With no operation
5
(Blinking)
(Blinking)
(Blinking)
Seconds
Reset the Peak Value
4
Release the switch
after setting is done
5
Back to normal display with
no operation for 5 seconds
Setting Completed
4
Press the switch
to change the brightness
(
)
(
High
Mid
Each pressing will change the brightness
Possible Solutions
Please reconfirm whether wiring and connections
are correct or not.
Please reconfirm the Fitting List.
3
for
Seconds
Press
Switch
)
(
)
Low
Advertisement
