Advertisement
SPOTLIGHT
A
Align this hole with hole
on end of crossbar
B
2
A) With the assistance of another adult, position
legs as shown. Insert 2 barrel nuts into the crossbar
as shown. Use a flat head screwdriver to align the
hole on the side of the barrel nut with the hole on the
end of the crossbar.
B) Fit dowels of crossbar and screw posts of leg
frames into corresponding holes as shown. Make
sure hole in screw post aligns with hole in the top of
the crossbar.
A
A) Place tabletop assembly upside down on a padded surface. Fit dowels of
4
legs into corresponding holes in tabletop.
B. Fully extend drawer. Secure both leg frames from the inside with 8 short
bolts, 8 split washers and 8 flat washers. Insert 4 long bolts, 4 split washers
and 4 flat washers through the tabletop apron as shown. Fully tighten, but do
not over tighten all bolts with a phillips head screwdriver.
With the assistance of another adult, place desk assembly upright.
Assembly is now complete.
Made in Vietnam - r03
DESK
Align this hole in
screw post
with hole in
top of crossbar
B
Customer Service 800.967.6696 | www.crateandbarrel.com
Secure crossbar to leg frames by inserting a set
3
screw into each barrel nut. Tighten with a phillips
head screwdriver, making sure set screw securely
engages the screw post of the leg frame.
NOTE:
Do not over tighten the bolts
Short Bolts
CORRECTLY ASSEMBLED
SIDE VIEW DETAIL
Long Bolt
CLEANING AND CARE
Clean surfaces with a dry or
damp soft cloth. Do not use
abrasive cleaners. Do not use
furniture wax or polish as the
wood is finished with a
protective clear lacquer.
Page 2 of 2
Advertisement
