Parkside PMML 5 A2 Operation And Safety Notes page 40

Horizontal laser line
1. Hold the product horizontally to a
soft surfaced wall (example: Wooden
wall). To do this, direct the product
so that the air bubble in the vial
lies between the two marked lines.
2. Slide both the stud buttons
firmly downwards. The nails lightly
penetrate on the soft surfaced wall to
prevent the multi-detector from falling
(see Fig. H)
Attention: Exercise care with the
studs. These are sharp and can
cause injury (see Fig. F). Do not use
the stud button on stone or metal
wall, but only on walls with a soft
surface (example: wooden wall).
Vertical laser line
1. Attach a thread to the eye at the
hanging point
2. Hang the product to a point (example:
on a nail on the wall), where you
would like to project the vertical line.
The product hangs vertically
40 GB
.
1
8
,
5 11