Step 5: Mount The Sem - Honeywell ADEMCO VISTA 10P Installation Manual

STEP 5: MOUNT THE SEM

You must be free of static electricity before handling electronic
components. Touch a grounded metal surface before touching
the circuit board.
Press down on the bottom tabs of the enclosure cover to remove it
and set it aside.
Carefully remove the SEM circuit board by depressing the interior
bottom tab.
Place the SEM back plate on the wall at the desired mounting
location and mark the three mounting holes as shown below.
Set the back plate aside and drill holes at the mounting locations.
Use wall anchors where studs are not present and secure the back
plate to the wall with the enclosed screws.
Insert the SEM circuit board back into the back plate.
8