Setup And Diagnostic; Inlet Power Voltage And Grounding; Performing The Self Test - Argox R Series Technical Manual

R-Series Technical Manual

5. SETUP AND DIAGNOSTIC

5.1 Inlet power voltage and grounding

The R-Series printer is designed for both 110V AC and 220V AC outlet. The line voltage should
not lower than 90V AC or higher than 250V AC and the printer should be connected to a
properly grounded receptacle.

5.2 Performing the self test

Once the printer is first installed, a self-test should be performed. To perform the self-test, please
follow the procedure:
1. Turn off the power.
2. Load the media and ribbon properly.
3. Press and hold the FEED button then turn on the power.
4. Release the FEED button after printer starts to print.
5. The configuration report will be printed out as Figure 5-1 and Figure 5-2.
6. To return the printer to normal operation, please turn the power OFF and ON again or
press the CANCEL button for one second, otherwise the printer will enter dump mode,
all input data will not be interpreted.
Contents and information of R-Series "Self Test Label" are as the following:
1. Printer programming language and version information
The printer programming language, firmware version and date information are listed
on the first line of the report.
2. RS-232 Protocols
It contains data frame of RS-232 interface: baud rate, parity, data bit number, and stop
bit number.
3. Standard RAM size
This message shows standard RAM size in the printer.
4. Available RAM size
This message shows available memory can be used to hold the downloadable graphics,
Argox Information Co., Ltd.
Rev. 1.02 November 24, 2008
15