Step 2: Connect And Calibrate The Scanner - Visioneer Strobe XP 200 Installation Manual

6 V S
ISIONEER TROBE
XP 200 S I
CANNER NSTALLATION
12. On the Visioneer Registration screen, complete the required
information and click Register.
13. When you see the Connect Scanner window, do NOT click Finish.
Leave the window open and proceed to the next section, "Step 2:
Connect and Calibrate the Scanner".
S 2: C
TEP ONNECT AND
The Visioneer Strobe XP 200 scanner connects to any available USB
port. Check your computer's manual for USB port locations.
Note: You can connect the scanner to your computer while the
computer is running. You do not have to shut down your computer.
To connect your Visioneer Strobe XP 200 scanner:
1. Plug the AC adaptor cable into the power jack on the USB/power
cable, and then plug the AC adapter into an electrical outlet.
2. Plug the XP 200 connector on the USB/power cable into the port
on the back of the scanner.
3. Plug the USB connector on the USB/power cable into any USB
port on your computer.
G
UIDE
C
ALIBRATE THE
S
CANNER