Table of Contents
Advertisement
Using the Smart Siren
This section assumes that your access to the Smart-Vue Pro
web platform and application is configured and you have
appropriate access rights to configure devices in the system.
You will need application manager role to access certain
configuration options.
Placement for Best
Wireless Performance
For optimal operation, follow these recommendations when
physically placing your device:
•
Do not place the siren within 40 cm (16 in.) of another
module or wireless device.
•
Make sure the wireless module is not placed on an
electrical conduit or cable tray (such as for computer
network cables).
•
For best results, place the module so that it faces the
general direction of the receiver antenna if possible.
•
Keep about 20 cm (8 in.) of clear space around the
module. For example, a module that is "stuck" between
two refrigerators may not communicate effectively.
•
Place your siren where people will not bump into it or
unplug it (no more than 2 meters (6.5 ft.) from the floor).
•
To ensure that the AC adapter does not get unplugged
accidentally, use a power socket that is also elevated
from the floor and/or shield the cord in a protective
conduit that is fixed to the wall (or within the wall).
The siren is a critical device in your wireless monitoring
system. Therefore, we recommend that you keep it plugged it
into an Uninterruptible Power Supply or safety plug.
Mounting Kit
CAUTION: For safety reasons, the siren should
be mounted less than 2 meters (about 6.5 feet)
from the floor.
1. For strong adhesion, wipe and dry the back of the siren
and the mounting surface on which you intend to place
the unit.
8 |
Using the Smart Siren
2. Velcro: Attach one side of the Velcro tape to the back of
the siren and the other on the wall where you intend to
place the unit.
Magnet: Remove the adhesive backing and attach the
magnet to the siren.
3. Place the siren on mounting surface.
AC Adapter
1. Plug the AC adapter into the siren as shown below. The
plug should slide firmly into the socket on the siren.
WARNING: Do not open the Smart Siren casing.
There are no user-serviceable parts inside.
Opening the casing voids the manufacturer
warranty.
2. Plug the AC adapter into an uninterruptible power supply
or wall outlet, a LED next to plug shall be turned ON in
GREEN.
3. When operating on battery, the LED turns to RED.
4. After 1 minute operation on battery, device shall turn
OFF, by emitting a notification to webapp.
Smart Siren User Guide
Advertisement
Table of Contents
