Key Automation HALO 900HA7 Instructions And Warnings For Installation And Use page 4

EN
combined with other devices;
the product may not be used until the automation
system "commissioning" procedure has been per-
formed as specified in the "Automation system te-
sting and commissioning" section;
the system power supply line must include a circuit
breaker device with a contact gap allowing com-
plete disconnection in the conditions specified by
class III overvoltage;
use unions with IP55 or higher protection when
connecting hoses, pipes or cable glands;
the electrical system upstream of the automation
system must comply with the relevant regulations
and be constructed to good workmanship stan-
dards;
this appliance can be used by children aged from 8
years and above and persons with reduced physi-
cal, sensory or mental capabilities or lack of ex-
perience and knowledge if they have been given
supervision or instruction concerning use of the
appliance in a safe way and understand the ha-
zards involved;
before starting the automation system, ensure that
there is no-one in the immediate vicinity;
before proceeding with any cleaning or mainte-
nance work on the automation system, disconnect
it from the electrical mains;
special care must be taken to avoid crushing
between the part operated by the automation sy-
stem and any fixed parts around it;
children must be supervised to ensure that they do
not play with the equipment;
drive is not to be used with doors having openings
exceeding 50mm in diameter or having edges or
protruding parts a person could grip or stand on;
that the drive cannot be used with a driven part
incorporating a wicket door unless the drive can
only be operated with the wicket door in the safe
position;
in the case of detection of an obstacle during its
closing travel, the garage door reverses its travel
direction, releasing the obstacle until it opens com-
pletely;
install the actuating member for the manual rele-
ase at a height less than 1,8m. If removable, the
actuating member should be stored in direct vicini-
ty of the door;
4
install any fixed control at a height of at least 1,5m
and within sight of the door but away from moving
parts;
permanently fix the labels warning against en-
trapment in a prominent place or near any fixed
controls (Fig. 1 Pag. 54);
after installation, ensure that the mechanism is
properly adjusted and that the drive reverses or
the object can be freed when the door contacts a
50mm high object placed on the floor (for drives
incorporating an entrapment protection system de-
pending on contact with the bottom edge of the
door);
after installation, ensure that parts of the door do
not extend over public footpaths or roads;
when the appliance is provided with a separa-
te stop button, that stop button shall be unambi-
guously identifiable.
ATTENTION !
Frequently examine the installation for imba-
lance where applicable and signs of wear or
damage to cables, springs and mounting. Do
not use if repair or adjustment is necessary.
ATTENTION !
The automation system component packaging
material must be disposed of in full observan-
ce of current local waste disposal legislation.
Key Automation reserves the right to amend
these instructions if necessary; they and/or
any more recent versions are available at www.
keyautomation.it.