Installation - WattBox WB-250-IPW-2 Quick Start Manual

INSTALLATION

NOTE: This device always connects via the wired connection while it is
physically connected to an active network switch port. The Wi-Fi capabilities
are only activated when the device is not hardwired to a network.
1. Ensure the WB-250 is connected by ethernet cable to the internet.
2. Check the IP address of the WB-250 using an IP scanner or the router's
client table. If your WB-250 will remain hardwired, skip to step 7 now.
Optional Steps for Wireless Operation
3. Navigate to the IP address of the WB-250, and log in to its local interface.
4. In the interface, navigate to Configure > Wireless IP Settings. Press the
Scan button.
5. Locate the SSID for your WAP or router. Select that SSID and log in to that
wireless network.
6. Disconnect the Ethernet cable (otherwise the WB-250 continues to operate
in wired mode). After a few minutes, the power LED turns from oraange to
green, indicating that the unit is now operating wirelessly.
Finishing the Install
7. Log in to your OvrC account.
8. Add the WB-250 using its MAC address and service tag (ST) number.
You can now complete setup through OvrC. Ensure your firmware is up to date,
schedule automatic reboots, and set up boot delays.
6