Safeguarding The Environment; Before Using The Appliance - Whirlpool WTH4714 A+M Instructions For Use Manual

SAFEGUARDING THE ENVIRONMENT

1. Packing
The packing material is 100% recyclable and is
marked with the recycle symbol
regulations for scrapping. Keep packing materials
out of the reach of children, as they are a potential
source of danger.
2. Scrapping/Disposal
The appliance is manufactured using recyclable
material.
This appliance is marked in compliance with
European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE).
By ensuring that this appliance is disposed of
correctly, you can help prevent potentially
damaging consequences for the environment and
human health.
The symbol on the appliance, or on the
accompanying documents, indicates that this
appliance should not be treated as domestic waste
but must be taken to a special collection centre for
the recycling of electrical and electronic
equipment.
When scrapping the appliance, make it unusable by
cutting off the power cable and removing the doors
and shelves so that children cannot easily climb
inside and become trapped.

BEFORE USING THE APPLIANCE

To ensure best use of your appliance, carefully read
the operating instructions which contain a
description of the product and useful advice.
Keep these instructions for future reference.
1. After unpacking the appliance, make sure it is
not damaged and that the door closes properly.
Any damage must be reported to the dealer
within 24 hours of delivery of the appliance.
2. Wait at least two hours before switching the
appliance on, to ensure that the refrigerant
circuit is fully efficient.
3. Clean the inside of the appliance before use.
Scrap the appliance in compliance with local
regulations on waste disposal, taking it to a special
. Follow local collection centre; do not leave the appliance
unattended even for a few days, since it is a
potential source of danger for children.
For further information on the treatment, recovery
and recycling of this product, contact your
competent local office, the household waste
collection service or the shop where you
purchased the appliance.
Declaration of Conformity
• This appliance has been designed for preserving
food and is manufactured in compliance with
Regulation (CE) No. 1935/2004.
• The appliance has been designed, manufactured
and marketed in compliance with:
- safety objectives of the "Low Voltage"
Directive 2006/95/EC (which replaces
73/23/EEC and subsequent amendments);
- the protection requirements of the "EMC"
Directive 2004/108/EC.
6