ZCS Azzurro ZSM-WIFI-KIT Complete Manual page 9

Technical Note "Complete Guide to Monitoring the Azzurro ZCS Systems via Wi-Fi" - Rev. 1.2 of 20/05/2019
5) From the list of wireless networks available, select your home Wi-Fi network, where you want to connect
the Wi-Fi card. Click "Next."
N.B.: make sure that the signal strength is greater than 30%; if not, make sure the antenna has been fully
extended by following the three steps shown in the figure.
If the antenna has been correctly extracted, bring the router closer or install a repeater or signal
amplifier.
Figure 11 – Procedure for extracting the antenna connected to the internal Wi-Fi card
Estrarre
Allentare
Serrare
Figure 10 – Screen for selecting the available wireless network (3)
Zucchetti Centro Sistemi S.p.A. - Green Innovation Division
Via Lungarno, 248 - 52028 Terranuova Bracciolini - Arezzo, Italy
www.zcsazzurro.com
Extract
Loosen
Fasten
Page 9 of 38