Checking The Correct Configuration Of The Wi-Fi Card - ZCS Azzurro ZSM-WIFI-KIT Complete Manual

Technical Note "Complete Guide to Monitoring the Azzurro ZCS Systems via Wi-Fi" - Rev. 1.2 of 20/05/2019
Check that the Wi-Fi adapter is correctly and securely connected to the inverter, making sure to
tighten the two cross screws supplied with the Wi-Fi adapter.
Check that the configuration has been carried out correctly, according to this procedure.
Check that the router is working properly and that it is connected.
Check that port 80 of the router is open and enabled for sending data. To do this, refer to the next
paragraph of the document.
5) Display condition:
After configuration, check that the fixed or flashing Wi-Fi symbol (the first, in the case of a LITE single-
phase inverter, and the second in the case of a three-phase inverter).
Figure 34 – Icons on the display of the LITE single-phase (left) and three-phase or hybrid (right) inverters
N.B.: to reset the configuration of the Wi-Fi adapter, press the reset button found on the back of the
adapter for 5 seconds. After releasing the key, the 3 LEDs will flash simultaneously until the adapter returns
to its initial configuration state. At this point, it is possible to repeat the configuration procedure again.
The adapter can be reset only when the inverter is on.
4 PROCEDURE FOR CHECKING THE CORRECT CONFIGURATION OF THE
WI-FI CARD
Position yourself in front of the inverter and check the following steps:
1) When searching for the Wi-Fi network using a smartphone or PC, make sure that the signal of your
home wireless network reaches the place where the inverter is installed (a minimum RSSI strength of
30% is required during configuration).
2) Connect to the inverter network AP_********, enter the IP address IP 10.10.100.254 on a browser,
use "admin" as the default username and password and access the wireless section on the left
column.
3) In the case of inverters equipped with internal Wi-Fi card, make sure that you have sufficiently
extended the antenna (about 6-7 cm) by following the three steps shown in the figure.
Zucchetti Centro Sistemi S.p.A. - Green Innovation Division
Via Lungarno, 248 - 52028 Terranuova Bracciolini - Arezzo, Italy
www.zcsazzurro.com
Page 23 of 38