Abus SE1000 Installation Manual page 6

Preface
Dear Customer,
Thank you for purchasing this surface-fitted/flush-fitting key switch. You made
the right decision in choosing this state-of-the-art technology, which complies
with the current standards of domestic and European regulations. The CE has
been proven and all related certifications are available from the manufacturer
upon request. To maintain this status and to guarantee safe operation, it is your
obligation to observe these operating instructions.
Notes
The key switch is equipped with a burglary/tamper sensor and is used for
switching on or off the alarm system of an entire location or sections of the
location.
It can also be used for controlling other electronic equipment such as machines,
garage doors, etc.
The key switch functions as an impulse or permanent contact, depending on the
settings. The key switch is well protected against external interference, thanks to
the cover contact and the anti-removal wall contact (surface-fitted model only),
as well as the reinforced fascia plate, which prevents removal of the high-quality
ABUS cylinder.
Main features
x
Surface-fitted or flush-fitting key switch
x
Stable, weatherproof casing
x
Reinforced fascia plate to prevent lock removal
x
Cover contact and anti-removal wall contact (surface-fitted model only)
x
Permanent or impulse contact
x
Coloured LEDs (red/yellow)
x
Modern, attractive design
Scope of delivery
4 special casing screws with key
1 circular seal black (SE1000 only)
1 sealing plate white (SE1100 only)
4 x 6mm wall plugs including 4.5 x 35mm screws
6