Hama Crabro Operating Instructions Manual page 7

• Fly the drone at an altitude of approximately 3 m.
• Press and hold the Loop button (7).
• Move the right control lever (6) upwards or
downwards to perform a loop.
• Move the right control lever (6) to the left or right to
perform a 360° roll sideways.
7.3 Tweaking the control (trimming)
Note – Trimming
• The drone should be smooth and stable in the air,
and should fly only in the direction that is set using
the control.
• After a certain time, there may be slight directional
tilts even though the control levers are in the resting/
neutral position.
• These directional tilts can be eliminated by trimming
the control.
Left/right
• If the drone continually tilts to the right during the flight,
briefly push the Tweaking button (11) to the left. Repeat
this step until the drone is aligned.
• If the drone continually tilts to the left during the flight,
briefly push the Tweaking button (11) to the right.
Repeat this step until the drone is aligned.
Forwards/backwards
• If the drone continually tilts forwards during the flight,
briefly push the Tweaking button (10) downwards.
Repeat this step until the drone is aligned.
• If the drone continually tilts backwards during the flight,
briefly push the Tweaking button (10) upwards. Repeat
this step until the drone is aligned.
7.4 Resetting the drone
Note
• Frequent/incorrect trimming can result in
misalignment of the drone.
• This can be eliminated by resetting the control to the
neutral position.
• Position the drone on a flat horizontal surface.
• If necessary, pair the drone with the remote control. (See
Section 7.1)
• Press and hold the Loop button (7) until the LEDs of the
drone (4) begin to flash.
• The LEDs stop flashing once the drone has been
successfully reset.
7.5 Speed levels
Note
• Three speed levels (low, medium, high) can be
selected.
• When you switch on the product, the drone is set to
the low speed level.
• Experienced pilots can increase the drone's speed by
selecting the medium or high speed level.
• Press the speed controller (1) to change the speed level.
7.6 Switching off the drone
• Land the drone.
• Move the left control lever (2) all the way down and hold
it there.
• Move the slide switch (7) on the drone to the OFF
position.
• Move the slide switch on the remote control (3) to the
OFF position.
8. Changing the rotor blades
• Remove the existing rotor blade by gently pulling it off
from the motor shaft.
• Lightly press the new rotor blade on the motor shaft.
• Make sure that the rotor blades are positioned correctly,
as otherwise the rotation direction will not be correct
and no drive is generated.
• The drone's charging socket (6) marks the rear part of
the drone.
B2
A1
A2
B1
10