Hama Crabro Operating Instructions Manual page 5

6.2 Model aircraft – charging the battery
Note
• The battery, drone and charging adapter included in
the delivery go together and should always be used in
combination.
• Fully charge the battery of the drone before using it for
the first time.
• Connect the supplied USB charging cable to the drone's
charging socket (6).
• Connect the unused plug on the USB cable to an
available USB port on your computer or another suitable
USB charger. Please refer to the operating instructions for
the USB charger used.
• The LED indicator of the USB charging plug is lit red
during charging. When the battery is fully charged, the
LED indicator goes out.
Warning – rechargeable battery
• Only use suitable charging devices with USB
connections for charging.
• As a rule, do not use charging devices or USB
connections that are defective and do not try to repair
them yourself.
• Do not overcharge the product or allow the battery to
completely discharge.
• Avoid storing, charging or using batteries in extreme
temperatures.
• When stored over a long period of time, batteries
should be charged regularly (at least every three
months).
• After every flight and before charging, allow the
motors and the battery to completely cool!
• Continually monitor charging!
• Stop charging immediately if the battery becomes hot
and/or deformed!
• Use a heat-resistant, fire-proof surface for charging!
Note – charging/battery capacity
• It takes approximately 30 minutes to fully charge the
battery.
• The battery comes partially charged. Initial charging
may therefore take less time.
• After a charging time of 30 minutes, the flying time is
approximately 6-8 minutes.
• The actual flying time varies according to use of the
product, the settings and ambient conditions (for
example, temperatures below 5°C and above 25°C
reduce battery capacity).
7. Flight mode
7.1 Pairing the drone with the remote control
• Place the drone on a level surface.
• Move the slide switch (7) on the drone to the ON
position. The LEDs (4) begin to flash.
• Move the slide switch on the remote control (3) to the
ON position.
• Move the left control lever (2) all the way up.
• Then move the left control lever (2) all the way down.
• A signal tone is emitted to confirm the pairing.
8