Hama EWS-152 Operating Instructions Manual page 9

Note – Summer time
• The clock automatically switches to summer time. S appears on the display as
long as summer time is activated.
• Press and hold the
search.
Manually setting the date/time
• Press and hold the
DCF signal. The wireless symbol (6) goes out and you can set the time manually.
• Press and hold the MODE button (8) for approx. 3 seconds to start manually setting
the date/time.
• Set the following information in the order listed:
• Time zone (difference in hours), hour, minute.
• To select individual values, press the
each selection by pressing the MODE button (8). .
• If you do not make an entry for 20 seconds, you automatically exit setup mode.
Note – Time zone
• The DCF signal can be received over long distances, but always transmits the
current Central European Time in Germany. Make sure you account for the time
difference in countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in Germany. This means that
you should set +3 for the time zone. The clock then automatically sets the time
to 3 hours after the DCF signal received or relative to the manually set time.
Celsius/Fahrenheit
• Press the button (9) to switch between °C and °F for the temperature display.
12/24 hour format
• Press the button (7) to switch the time between the 12 and 24 hour format.
6.3 Low battery capacity
As soon as the battery symbol (2) appears on the display of the base station, the
capacity of the batteries in the measuring station is very low. Replace the batteries
immediately.
8
button (9) again for approx. 3 seconds to stop the manual
button (9) for approx. 3 seconds to stop the search for the
button (7) or the button (9) and con rm