Related Manuals for cecotec Conga 3090 Series
Summary of Contents for cecotec Conga 3090 Series
- Page 1 The expert for robots in your home With one click to the online shop myRobotcenter.eu myRobotcenter.co.uk myRobotcenter...
- Page 2 Manual de instrucciones Instruction manual Manuel d’instructions Bedienungsanleitung Manuale di istruzioni Manual de instruções...
- Page 4 ÍNDICE INHALT 1. Piezas y componentes 1. Teile und Komponenten 2. Instrucciones de seguridad 2. Sicherheitshinweise 3. Montaje 3. Bevor dem ersten Gebrauch 4. Funcionamiento 4. Betrieb 5. Limpieza y mantenimiento 5. Reinigung und Wartung 6. Cambio y carga de la batería 6.
-
Page 5: Parts And Components
ENGLISH 1. PARTS AND COMPONENTS Main body Cover Back home : Home Power button/Automatic cleaninga Spot cleaning: Laser Light indicator Operating: steady blue light Recharging/low power: yellow light blinks slowly Charging: yellow light oscillates Network configuration: blue light flashes slowly Start-up/firmware update: blue light oscillates Error: red light flashes quickly... - Page 6 ENGLISH Main body and sensors Charging sensor Driving wheel Main brush cover Bumper Free-fall sensor Laser sensor Omnidirectional wheel Side brush Main brush Water tank Dripping holes Water tank release Water-filling hole Water tank button Velcro...
-
Page 7: Safety Instructions
• This product must be used in accordance with the directions in this instruction manual. Cecotec cannot be held liable or responsible for any damages or injuries caused by improper use. • Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the wall outlet is grounded. -
Page 8: Before Use
ENGLISH children over the age of 8, as long as they are given continuous supervision. • This appliance can be used by children aged 8 and above, and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, as long as they have been given supervision or instruction concerning the use of the appliance in a safe way and 3. -
Page 9: Operation
ENGLISH Install the water tank Note: it is not suggested to use the scrubbing function for the first-time use. Attach the mopping cloth to the bottom part of the water tank and fix it properly. Open the water tank’s rubber lid, fill it up with water and close it again. - Page 10 ENGLISH 4.1. ROBOT BUTTONS 1. AUTO mode Press on the robot for it to start cleaning automatically in zig-zag, recognizing which areas it has cleaned and which ones it has not. The robot will plan the cleaning route automatically as it is cleaning. If during this mode the robot is directed manually, it will re-plan the route and could repeat already-cleaned areas.
-
Page 11: Remote Control
ENGLISH 4.2. REMOTE CONTROL Schedule Spot cleaning Back home Time Manual control On/Pause Power levels (Turbo/Normal/Eco) Edge mode • The following operation and modes can be activated from the remote control. MODES The first time the robot is operated, it will map and memorize the whole house by means of its laser before starting the cleaning cycle. - Page 12 ENGLISH 2. Spot-cleaning mode While the robot is paused or in standby mode, press on the remote control to activate Spot-cleaning mode. The robot will clean within a 2*2 space. This mode is commonly used to clean floors where dust is concentrated.
- Page 13 ENGLISH on the App, the remote control or on the robot to start it up again. Warning: • After 12 hours of no operation, the robot will turn automatically off. • The robot will not enter sleeping mode during charging. SUCTION POWER LEVEL POWER Press POWER on the remote control to select the desired power level.
- Page 14 ENGLISH Cleaning scheduling 1. Long press the button. The first 2 digits, indicating the hour, will start blinking. 2. Use the up and down direction buttons and the POWER button to set the current time. The, use the left and right buttons to switch from hours to minutes and repeat the before step.
-
Page 15: Cleaning And Maintenance
ENGLISH • Check the cleaned surface and the time taken. • Check the cleaning history. Configuration: • Download the Conga S3090 App from App Store or Google Play. • Create an account with your e-mail and a password. • Confirm login. •... - Page 16 ENGLISH DUST TANK Remove the robot’s cover and take out the dust tank. Take the HEPA filter’s cover out and empty the dust. Install the HEPA filter pack in its place. Introduce the dust tank back into the robot, fold the handle down and put the cover back.
-
Page 17: Hepa Filter
ENGLISH HEPA FILTER Remove the HEPA filter and shake it to remove all the dust. Note: Clean the filter periodically with a brush. Do not wash the filter with water. MAIN BRUSH Remove and clean the main brush regularly. SIDE BRUSH Remove and clean the side brushes regularly. -
Page 18: Troubleshooting
ENGLISH 7. TROUBLESHOOTING Problem Solution The robot does not start up - The robot cannot operate when the battery is low. Allow it to charge before operating it. - The room temperature is below 0 ºC or above 40 ºC. Opera- te the robot in a room where the temperature is between 0 and 40 ºC. -
Page 19: Disposal Of Old Electrical Appliances
In the event of misuse, the warranty will not apply. If at any moment you detect any problem with your product or have any doubt, do not hesitate to contact Cecotec Technical Support Service at +34 963 210 728. - Page 22 Grupo Cecotec Innovaciones S.L. C/de la Pinadeta s/n, 46930 Quart de Poblet, Valencia, Spain www.cecotec.es...