Connecting The Pto Shaft - Toro ProCore SR54 Operator's Manual

10

Connecting the PTO Shaft

Parts needed for this procedure:
1 Pin (supplied with PTO shaft)
1 Nut (supplied with PTO shaft)
Procedure
Note:
You can open the access panel
ease the removal and installation of the PTO shaft
mounting fasteners.
1. Remove the pin and nut from the PTO shaft
(Figure 23).
2. Connect the clutch end of the PTO shaft to the
aerator gearbox input shaft with pin and nut
previously removed
inserted only one way.
Figure 23
1. Gearbox input shaft
2. PTO shaft coupler
Note:
Close and latch the PTO shield access
panel if opened.
Note:
Ensure that the pin is fully inserted into
the yoke of the PTO.
3. Connect the PTO shaft to the tractor PTO shaft
(Figure 24).
(Figure 22) to
(Figure 23). The pin can be
3. Pin
4. Nut
1. Tractor output shaft
2. PTO shaft coupler
4. Slide the PTO shaft forward as far as the tractor
allows.
5. Pull back the locking collar to secure the PTO
shaft in place. Slide the PTO shaft back and
forth to ensure that it is properly locked.
6. Connect the shield safety chains to the PTO
shield and the tractor bracket
Ensure that the chains remain slack when the
aerator is raised or lowered.
g010850
1. Safety chains
Note:
To avoid excess lift, connect the lift arms
of the tractor into the top holes of the lift bracket,
if so equipped
on the PTO shaft is 35°.
15
Figure 24
3. PTO shaft
(Figure
Figure 25
(Figure 26). The maximum angle
g007328
25).
g010852