Troubleshooting - Silvercrest SHBR 560 A1 Operating Instructions Manual

Troubleshooting

The following table will help you to identify and rectify minor malfunctions. If the
solutions presented below do not resolve the problem, please contact Customer
Service (see section Service).
Fault Cause
The appliance is not
switched on.
The plug is not
plugged in.
The appliance
The mains socket is
will not switch
not supplying any
on.
power.
The waste water
tank
The appliance is
defective.
The fresh and waste
water tanks
are not properly fitted.
The waste water tank
2
The suction
power is too The splash guard
weak. is not fitted properly.
The suction channel is
blocked.
The dirt filter
blocked.
■ 22 │ GB │ IE │ NI
Remedy
Make sure that the appliance is properly
connected to the power supply.
Press the hard floor switch
switch
Insert the plug into the mains power socket.
Check the house mains fuse.
Empty the waste water tank
2
is full.
Cleaning the waste water tank).
Switch the appliance off and pull out the mains
plug.
Contact Customer Service (see section Service).
Attach the fresh and waste water tanks
properly to the appliance (see sections
q/2
Filling the fresh water tank and Cleaning the
waste water tank).
Empty the waste water tank
is full.
Cleaning the waste water tank).
7
Fit the splash guard
section
Clean the suction channel and remove the
blockage (see sections Self-cleaning function
and Manual cleaning).
0
is Remove the dirt filter
tion Cleaning the waste water tank).
e
to switch the appliance on.
2
2
7
properly onto the foot
3
(see section Manual cleaning).
0
and clean it (see sec-
r
or the carpet
(see section
q/2
(see section
SHBR 560 A1