Epson BrightLink Pro 1430Wi Installation Manual page 9

4 Installing the Touch Unit (BrightLink Pro 1430Wi)
The following procedures must be completed before installing the Touch Unit:
•
Installing the projector (see the ELPMB28 Installation Guide)
•
Adjusting the projected image (see the ELPMB28 Installation Guide)
•
Calibrating the interactive pen(s)
s Refer to your projector User's Guide or Start Here folder for detailed instructions.
❏
There are magnets built in to the back of the Touch Unit. Typically, the Touch Unit
should be installed by attaching the magnets to the screen or whiteboard.
❏
If the magnets cannot be attached, use commercially available M4 screws (×3).
❏
Install the Touch Unit on a flat, smooth, unwarped surface that is the same level
surface as the screen surface. If there is unevenness on the screen surface of more
than 0.2 in. (5 mm) in any direction, your fingers may not be detected and finger
touch operations may not be performed correctly.
Follow the steps below to install the Touch Unit and connect to the projector. Some menus may differ slightly
from the illustrations, but the installation instructions are the same.
Caution
The Touch Unit should only be connected to the BrightLink Pro 1430Wi. Do not connect the
Touch Unit to any other projectors or devices.
A
Turn on the projector
B
Display the installation pattern
1. Select Easy Interactive Function from the Extended menu.
Using the Remote Control Using the Control Panel