Epson BrightLink Pro 1430Wi Installation Manual page 22

5 Installing the Control Pad
You must install the control pad on the same surface as the projector, within the range specified in the
installation instructions. You can use batteries to power the control pad, or the optional remote control cable
set (model ELPKC28, part number V12H005C28).
You must have completed the steps in "Installing the Projector" in the Installation Guide before installing the
Control Pad.
Follow the steps below to install the Control Pad and connect to the projector.
Caution
The Control Pad should only be connected to the BrightLink Pro 1420Wi/1430Wi. Do not
connect the Control Pad to any other projectors.
Check the installation location
The Control Pad must be installed in the area specified in the diagram below.
13.8 in.
35.4 in. 27.6 in.
78.7 in. 68.9 in.
(0.7 m) (0.35 m)
(0.9 m)
(2.0 m) (1.75 m)
Make sure there is enough space surrounding the Control Pad. Because the top panel
opens from the left, there must be additional space to the left of the Control Pad.
9.8 in.
(0.25 m)
60-inch
image
100-inch
image
39.3 in. (1.0 m)
59.0 in. (1.5 m)
78.7 in. (2.0 m)
2 in. (50 mm)
3.9 in
(100 mm)
2 in. (50 mm)
Remote control
light emitting areas
2 in
(50 mm)