Remove The Cable Cover - Epson BrightLink Pro 1430Wi Installation Manual

A

Remove the cable cover

B
Attach the Control Pad
Attach the Control Pad with commercially available M4 × 20 mm screws (×4).
Warning
❏
Make sure the screws are not angled.
❏
Make sure the Control Pad is firmly attached.
❏
Do not attach the Control Pad with double-side tape or magnets.
❏
Check that the Control Pad is operating correctly before attaching it with the
screws.
❏
When installing the Control Pad on a table, attach the supplied rubber feet (x4) to
the base of the Control Pad to prevent it from slipping.