Table of Contents
Advertisement
The times are set prior to the unit being supplied
but they can be adjusted as necessary.
To select the test standard or the units of
measure press the right hand icon.
In this menu you can then choose the following;
CO
sample rate, pressure and temperature units
2
of measure and the breathing-air test standard.
Once you have made your selection press the
arrow in the top right corner to exit. To then exit
from the configuration sub menu to the main
menu press the arrow at the top left of the
screen.
4. Initiating a Breathing-Air Test
To carry out a test press the "Begin Test" icon on
the main menu.
Should mains power not be connected and both
battery sources low, a battery icon shall be
displayed on-screen and it will not be possible to
proceed with a test.
Connect either the mains power or replace the
AA alkaline batteries, and restart the tester.
8
FAC QAM 190 Issue D 09/18
Advertisement
Table of Contents
