Selecting The Test Standard And Configuring The - Factair SAFE-AIR TESTER F4501 Operating Manual

Note – If the begin test icon is in greyed out this
will be because no test results are currently stored
on the tester.
Note – If the begin test icon is in greyed out this
will be because the instrument's memory is full
(20 tests maximum) and you need to remove at
least 1 test before you can proceed. See Section 4
– Reviewing Test Results for further details.
3. Selecting the test standard and configuring the instrument
From the main menu press the Configure icon.
In the configuration sub menu there are 3 icons
available, from left to right these are:
Set Date
Set Time (the instrument uses a 24 hour clock)
Set units of measure and test standard
To set the date, press the calendar button on the
display as seen above.
In this menu you can then choose date format;
DD/MM/YYYY or MM/DD/YYYY
7 FAC QAM 190 Issue D 09/18