Panel Descriptions - Bogen ANS501 Installation And Use Manual

Panel Descriptions

1. Aux Input - Mono summing, stereo, unbalanced RCA inputs on side panel.
2. AUX Level Control - Controls the AUX input level feed directly to the output.
3. Unbalanced Input - High-impedance unbalanced RCA input on side panel.
4. Balanced Input - High-impedance electronically balanced input (pluggable screw terminal).
5. Sensor MIC Input - Input connections for ANS500M sensor microphone(s) (pluggable screw terminal).
6. Defeat Input - The effects of the ANS501 will be defeated when these terminals are shorted together (plug-
gable screw terminal).
7. Balanced Output - Low-impedance electronically balanced output (pluggable screw terminal).
8. Unbalanced Output - Low-impedance unbalanced RCA output on side panel.
9. Maximum Boost - Sets the maximum signal gain for the ANS501.
10. Ramp Speed - Sets the speed by which signal gain is increased/decreased once the ambient noise level is
above/below the threshold.
11. Power Connection - Barrel type power input connector on side panel.
12. Power LED - Green LED illuminates when power is present.
13. Status LED - Bi-color LED illuminates when different thresholds are triggered to assist in setup.
14. Ambient Threshold Control - Sets the ambient noise threshold level.
15. Activity Threshold - Sets reference level of typical audio program material applied to the unit.
16. Mode Switch - Facilitates setup of the module settings.
17. Relative Gain Control - Sets the difference between the ambient noise level and page level that the ANS501
will attempt to maintain.
5