10
20
30
40
50
70
80
4. Verify that the speedometer reading is within the range indicated in the table.
If the speedometer does not move or the indication is not within the allowable range, inspect the
•
ABS HU/CM (vehicles with ABS), DSC HU/CM (vehicles with DSC) and related wiring
harnesses.
If the ABS HU/CM (vehicles with ABS), DSC HU/CM (vehicles with DSC) and related
wiring harnesses are normal, replace the instrument cluster.
Tachometer
Using the input/output check mode
1. Inspect the tachometer by setting it to check code 13 of the input/output check mode.(See
INSTRUMENT CLUSTER INPUT/OUTPUT CHECK MODE .)
Using WDS or external diagnostic equipment
CAUTION:
If the engine speed exceeds the allowable range, the engine could be damaged.Therefore, when
•
inspecting the tachometer, do not allow the engine speed to exceed the allowable range indication on the
tachometer.
1. Connect the WDS or external diagnostic equipment to the diagnostic connector 2 (16-pin).
2. Compare the data monitor item (RPM) with the tachometer indication.
If the tachometer does not operate properly, inspect the PCM and related wiring harnesses.
•
If the PCM and related harnesses do not have any malfunction, replace the instrument
cluster.
Fuel gauge
911
1921
2931
3941
4951
6971
7882
(w)
RX-8 Body
Page 394