Titanium Footrest With Flat Abs Cover (Zr Series); Adjusting The Height Of The Footrest; Replacing The Footrest - TiLite Rigid TR Series Owner's Manual

Titanium Footrest with Flat ABS
Cover
(ZR Series)

Adjusting the Height of the Footrest

Tools Needed:
• 5/32" Allen Wrench
• Plastic Mallet
• Ruler
1. Loosen the Allen Screws in the two clamps that
secure the footrest to the frame. See Figure 4.
Loosen each Allen Screw until the entire head of the
screw is completely visible outside the clamp.
2. Tap the head of each screw with a plastic mallet to
release the wedge inside the frame tube. This will
allow the footrest to move freely.
3. Place the end of a ruler on the floor and hold it
vertically against the left corner of the footrest. See
Figure 5. Adjust the left side of the footrest to the
desired height (not less than 2" of ground clearance)
and tighten the Allen Screw in the left clamp so the
left side of the footrest cannot change.
4. Repeat the procedure from step 3 above on the
right side of the footrest.
5. When both sides are set at an equal distance from
the floor, make sure all four wheels are in contact
with the floor and then fully tighten the two Allen
Screws in the clamps that secure the footrest to the
chair frame, making sure the clamp remains
securely butted up against the end of the frame
tube.

Replacing the Footrest

Tools Needed:
• 5/32" Allen Wrench
• Plastic Mallet
• Ruler
1. Loosen the Allen Screws in the two clamps that
secure the footrest to the frame. See Figure 4.
Loosen each Allen Screw until the entire head of the
screw is completely visible outside the clamp.
2. Tap the head of the screw with a plastic mallet to
release the wedge inside the frame tube. This will
9
allow the footrest (along with the clamp, wedge and
8
7
Allen Screw) to be completely removed.
6
5
3. Insert the new footrest into one clamp and, holding
4
3
the wedge in place against the clamp, partially screw
2
1
the Allen Screw into the clamp and the wedge.
Repeat this procedure with the other clamp and
wedge.
4. Slide both clamps into both frame tubes until each
clamp is securely butted against the end of each
frame tube.
5. Place the end of a ruler on the floor and hold it
vertically against the left corner of the footrest. See
Figure 5. Adjust the left side of the footrest to the
26
Clamp
Allen Screw
Footrest
Figure 4
ZR Series Titanium Footrest Replacement
9
8
7
6
5
4
3
2
1
Figure 5
ZR Series and Aero Z Titanium Footrest Height
Adjustment
Frame Tube
Wedge
9 9
8 8
7 7
6 6
5 5
4 4
3 3
2 2
1 1
TiLite ® OM000007 - Rev. B