Advertisement
)
J
I
Bad Cuts (crooked)
Bad Cuts (Rough)
Blade is twisting
1.Feed pressure too great
2. Guide bearings not adjusted
properly
3.lnadequate blade tension
4.Dull blade
5.Speed incorrect
6. Blade guides spaced out too much
7.Blade guide assembly loose
8. Blade truck too far away from wheel
flanges
1. Too much speed or feed
2.Blade is too coarse
3.Blade tension loose
1. Cut is binding blade
2. Too much blade tension
-12-"
1. Reduce pressure by increasing spring
tension on side of saw
2. Adjust guide bearing, the clearance can
not greater than 0.001
3. Increase blade tension by adjust blade
tension
4. Replace blade
5. Adjust speed
6. Adjust guides space
7.1ighten
8. Re-track blade according to operating
instructions.
1. Decrease speed or feed
2. Replace with finer blade
3. Adjust blade tension
1. Decrease reed pressure
2. Decrease blade tension
Advertisement
