Assembly And Set Up - Razor HOVERTRAX PRIZMA Owner's Manual

ASSEMBLY AND SET-UP
Calibration Confirmation
Note: Your Hovertrax Prizma should have been calibrated at the factory.
1
Place Hovertrax Prizma on a level surface.
Calibrating Hovertrax Prizma
1
Place Hovertrax Prizma on a level surface.
3
While keeping the product level, turn power ON and HOLD until product
beeps and lights flash (approximately 15-20 seconds).
5
Calibration complete.
Note: Once the product has been calibrated, no matter what position (angle)
the platforms are in when it is turned off, the platforms will automatically
self-balance themselves back to the calibrated position when product is
turned on.
2
Turn power ON. If product remains level or adjusts to become level,
calibration has been confirmed. No further steps are needed.
If product begins to roll or does not move into a level orientation, see
Calibrating Hovertrax Prizma.
2
Manually adjust the platforms so they are level to the ground.
4
Turn power back OFF.
5