Table of Contents
Advertisement
Slide the actuator with its brackets back into the square hole of the installation and secure it with four (4)
of the supplied bolts and lock washers, through the predrilled holes.
Do not over tighten the bolts. Damage to the tee nut could occur.
2.3 Front Left Actuator
Repeat previous steps for the left actuator. Note that the right side of the installation is actually on your
left, as you face the installation.
2.4 Rear Actuator
Using the supplied bolts and lock washers, secure the rear actuator bracket to the rear of the installation
through the predrilled holes.
Do not over tighten. Damage to the tee nut could occur.
Using the supplied bolts and lock washers, secure the rear actuator to the rear actuator bracket using the
bottom set of holes.
Do not over tighten. Damage to the actuator could occur.
Use center holes
7 of 15
Advertisement
Table of Contents
