General Information - Viking 15" W Use & Installation Instructions Manual

GENERAL INFORMATION

Unpack
1. Remove banding from bottom of carton. Lift carton up and off of the ice machine
2. Remove all tape and packaging material from the outside and inside of the cabinet.
3. Keep all carton packaging until your ice machine has been thoroughly inspected and found to be in good
condition.
Area Requirements
1. Place unit so the front side will be completely unobstructed to provide proper air flow. The unit may be closed in
on the top and three sides, but the front M M U U S S T T B B E E unobstructed for air circulation and proper operation.
Installation should be such that the cabinet can be moved for servicing if necessary.
2. Unit should be in a well ventilated area. Best results are obtained at temperatures between 55
(27 0 C) for built-in indoor models, between 55
45 0 F (7.2 0 C) and 110
3. Provisions for electricity should be determined before placing unit in proper place.
4. For best performance, outdoor units should be installed away from direct sunlight or under a counter or sink.
UNDERCOUNTER CABINET
CUTOUT
A A
15" (38.1 cm)*
B B
Min. 34 1/2" (87.6 cm)
Max. 35 1/8" (89.2 cm)
C C
24" (61.0 cm)
*15" (38.1 cm) width for cabinet only. If door
is recessed between cabinets, cabinet cutout
must be 15-1/4" (38.7 cm.).
0 F (43 0 C) for outdoor models.
0 F (13 0 C) and 90 0 F (32 0 C) for indoor freestanding models, and between
C
2
0
A
B
F (13 0 C) and 80 0 F