AeroGarden Wall Farm Deluxe Single Assembly/Installation Instructions

Selecting Wall Farm Location

19"
Wall Farm must
be attached to
and centered on
a wood stud.
Place your Wall Farm in a
location with:
•
29" height to allow space for the full
extension of raised lamp hood.
•
19" width
•
Easy access to a standard electrical
outlet (110V, polarized)
Away from:
•
Direct sources of heat
(e.g., stove, furnace vents)
•
Direct sources of cold
(e.g., window drafts, A/C vents)

Tools Needed

You will need the following tools to
assemble and install your Wall Farm:
• •
Tape Measure
13/64" Drill Bit
•
(or smaller, e.g., 5/32")
Pencil
•
• Phillips Head
Drill
Screwdriver
Wall Farm Deluxe Single
Assembly & Installation Instructions
Wall Farm Deluxe Single
Assembly & Installation Instructions

Box Contents:

29"
1 AeroGarden Shelf
with Mounting Bracket
1 Top Mounting Bracket
Locate and mark center line
on wood stud.
Hold AeroGarden Shelf with
Mounting Bracket at desired
height and mark locations for
pilot holes.
Place base of Top Mounting
Bracket at mark made in Step 2
and mark locations for pilot holes.
TM

Unpack Your Wall Farm

Shelf
Supports
Cut Outs
4 Screws 1 Bottom Cover Plate

Mark and Drill Pilot Holes

center
line of
wood
stud
Wall Farm must
be attached to
and centered on
a wood stud.
Measure up 10" from top pilot
hole mark and mark wall for
Top Mounting Bracket.
center
line of
wood
stud
pilot hole
marks
Drill four 1- 1/2" deep pilot
holes with 13/64" drill bit.
1 Top Cover Plate
pilot hole
marks
pilot hole
marks
center
line of
wood
stud