Measurement Computing WebDAQ 504 User Manual page 8

Security
Use the web interface to set the level of access to the website and to change the administrator password.
High: access to the web page requires a password.
Medium: access to the web page is permi ed for any user, and data can be read by any user, but changes
to the device configura on or files require a password.
Off: full access is permi ed for all users; no password is required.
By default, security access is set to "Off", and the administrator password is set to "admin". To change the
security level or password, open the web interface and go to the Device window, Security tab. Use the device
Reset bu on to restore security se ngs to factory default values.
Restoring factory default se ngs
To restore network configura on and security se ngs to the factory default values, use a paper clip to press
the CONFIG RESET bu on. When pressed, the default network and security se ngs are wri en to the device
and the WebDAQ is rebooted.
Parameter
IP address
subnet mask
Gateway
DHCP se ng
Security level
Password for the admin
account
Password for the share
account
Device name
The network se ngs, security level, user account passwords and device name can be changed with the
WebDAQ web interface.
When factory defaults are restored, any shared folders or mapped drives are reset.
Contents
WebDAQ 504 User's Guide
Factory default se ngs
Specifica on
192.168.0.101
255.255.255.0
192.168.0.1
DHCP + link-local enabled
Off
admin (case-sensi ve)
share (case-sensi ve)
webdaq-xxxxxx, where xxxxxx is the last 6 digits of the MAC address
(printed on the label on the underside of the device).
page 8