Advertisement
Connecting to a power source
Connect the KONOse to a C-terminal, or use the KONOse
with batteries.
Connecting to a C-terminal
About this task:
Important: Make all wiring connections in
accordance with local, national, and regional
regulations. Do not exceed the electrical ratings of
the KONOse.
1.
Turn off the power to the heating and cooling
systems at the circuit breaker.
2.
Use the photo of your existing thermostat's wiring
as a guide to wire your KONOse.
3.
Reattach the KONOse to the base.
4.
Turn the power back on.
Inserting batteries
1.
Secure any wires that extend out of the wall so that
the wires cannot make contact with the thermostat.
2.
Insert four batteries into the base.
3.
Reattach the KONOse to the base.
Setup and adjustments
Device inclusion
About this task:
The thermostat prompts you to pair the device with your
Smart Hub at the initial setup. You can manually pair the
device at any time if you choose to skip this step at the
initial setup.
To manually pair your device, complete the following
steps:
1.
From the Home screen, press and hold the knob
for 5 seconds to enter the main menu.
Turn the knob to select the Connection icon, then
2.
press the knob to select the Inclusion menu.
Figure 1: Connection icon
Turn the knob to select Add, then press the knob to
3.
confirm.
The device displays Scan on the screen while it
prepares to add to the hub.
4.
At the hub portal, click Add device.
The device displays Done when the device is added
successfully.
2
KONOse Quick Start Guide
If the device did not add successfully, ER:02
shows on the display. Press and hold the
knob for more than 5 seconds to return to the
Inclusion menu and retry to pair the device.
Result The device automatically returns to the Home
screen after 5 seconds.
Device exclusion
About this task:
To remove the device from your Smart Hub, complete the
following steps:
From the Home screen, press and hold the knob
1.
for 5 seconds to enter the main menu.
2.
Turn the knob to select the Connection icon, then
press the knob to select the Inclusion menu as
shown in Figure 1.
Turn the knob to select RST, then press the knob to
3.
confirm.
The device displays Scan on the screen while it
prepares to remove from the hub.
4.
At the hub portal, click Remove device.
The device displays Done when the device is removed
successfully.
If the device did not remove successfully,
ER:02 shows on the display. Press and hold the
knob for more than 5 seconds to return to the
Inclusion menu and retry to remove the device.
Changing the control mode
About this task:
To switch the control mode between Heat, Cool, Auto, or
Off, complete the following steps:
1.
From the Home screen, press the knob once to
turn on the backlight, then press the knob again to
enter the Control Mode menu.
In the Control Mode menu press the knob to select
2.
the preferred mode.
Do not interact with the thermostat for 5 seconds for
the thermostat to confirm the selection.
Figure 2: Control modes
Adjusting the temperature
• From the Home screen, turn the knob clockwise or
counterclockwise to select the preferred temperature.
Do not interact with the thermostat for 5 seconds for the
thermostat to confirm the selection.
Advertisement
