Table of Contents
Advertisement
3.1
System Test and Initialization
The system uses certain routines to perform testing and initialization during the boot
up sequence. If an error, fatal or non-fatal, is encountered, the system will output a few
short beeps or display an error message. The system can usually continue the boot up
sequence with non-fatal errors.
The system configuration verification routines check the current system configuration
against the values stored in the CMOS memory and BIOS NVRAM. If a system
configuration is not found or an error is detected, the default configuration will be
loaded and the system will reboot automatically.
There are four situations in which you will need to setup system configuration:
1. Starting the system for the first time
2. Hardware configuration has been changed
3. System configuration was reset by the Clear-CMOS jumper
4. The CMOS memory has lost power and the configuration information has been
erased
The system CMOS memory has an integral lithium battery backup for data retention.
The battery must be replaced when it runs down.
Chapter 3 – AMI BIOS Setup
33
Advertisement
Table of Contents
