Bosch GRL2000-40H Operating/Safety Instructions Manual page 25

Remote control
Safety Notes
Read and observe all
instructions. SAVE THESE
INSTRUCTIONS FOR FUTURE
REFERENCE.
Have the remote control
repaired only through a
qualified repair person and only using
identical replacement parts. This will
ensure that the functionality of the remote
control is maintained.
Do not operate the remote control in
explosive atmospheres, such as in the
presence of flammable liquids, gases or
dusts. Sparks can be created in the remote
control which may ignite the dust or fumes.
Read and strictly obser ve the safety
warnings in the operating instructions of the
rotational laser.
Product Description and Specifications
Intended Use
IEC 60825-1:2007-03
T h e re mote c ont rol i s i n te nd ed fo r
< 1 mW, 635 nm
controlling Bosch rotational laser levels with
infra-red receivers, in indoor and outdoor
use.
Product Features
The numbering of the product features
refers to the illustration of the remote
control on the graphics page 24.
1a
Hibernation mode button
2a
Operation indicator
3a
Sweep mode button
4a Y-axis negative direction button
5a Button for "rotation in clockwise
direction"
6a
X-axis negative direction button
7a Button for "rotation in counter
clockwise direction"
8a
Y-axis positive direction button
9a
Button for rotational operation and
selection of the rotation speed
10a Button for slope operation or
full auto-leveling
11a X-axis positive direction button
12a Battery lid
13a Latch of battery lid
14a Outlet opening for infrared beam
15a Serial number
2610055315 GRL2000-40 02-20.indd 25
Technical Data
Remote Control
Article Number
1
Working Range
Operating Temperature
Storage Temperature
Batteries
Weight
1) The working range can be decreased by
unfavourable environmental conditions (e.g. direct
sun irradiation).
Please observe the article number on the type
plate of your remote control. The trade names
of individual remote controls may vary. For clear
identification of your remote control, see the serial
number on the type plate.
Assembly
Inserting/Replacing the Battery
Using alkaline batteries is recommended
for operation of the remote control. To
open the battery lid 12a, pull on the latch
13a and remove the battery lid. Insert the
batteries. When inserting, pay attention
to the correct polarity according to the
representation on the inside of the battery
compartment.
The batteries must be replaced when
operation indicator 2a no longer lights up
after pressing any button on the remote
control.
Always replace all batteries at the same
time. Only use batteries from one brand and
with the identical capacity.
Remove the batteries from the remote
control when not using it for longer
periods. When storing for longer periods,
the batteries can corrode and discharge
themselves.
Operation
Initial Operation
Protect the remote control against moisture
and direct sunlight. Do not subject the
remote control to extreme temperatures or
variations in temperature. As an example,
do not leave it in vehicles for longer periods.
In case of large variations in temperature,
allow the remote control to adjust to the
ambient temperature before putting it into
operation. The remote control remains
ready for operation as long as batteries with
sufficient voltage are inserted.
-25-
RC4
3601K69S10
100-ft
+14ºF to 122ºF (-10ºC to +50ºC)
-4ºF to 158ºF (-20ºC to +70ºC)
2 x AA1.5v Alkaline
3.8 oz
3/2/20 7:07 AM