National Instruments PCI-7041 User Manual page 26

Physical
Environment
RTSI
I/O Daughterboard
Adding RAM
National Instruments has tested and verified that the SO-DIMMs we carry work with
Note
the PCI-7041. We recommend you purchase your SO-DIMM modules from National
Instruments. Other off-the-shelf SO-DIMM modules are not guaranteed to work properly.
© National Instruments Corporation
Dimensions (Not Including Connectors)
PCI-7041 ................................................ 31.2 by 11.2 cm (12.3 by 4.4 in.),
Accessory board ..................................... 3.8 by 10.7 cm (1.5 by 4.2 in.),
Operating temperature............................ 0 to 50 °C
Storage temperature ............................... –20 to 70 °C
Relative humidity ................................... 10 to 90%, noncondensing
Refer to the RTSI section of Chapter 1, Introduction, for information about
real-time system integration.
Refer to the appropriate I/O device manual for more information about I/O
daughterboard specifications.
To add RAM to the PCI-7041, remove the unit from the computer. Remove
the SO-DIMM currently in the socket and add the new SO-DIMM to the
SO-DIMM socket. National Instruments recommends the following types
of SO-DIMMs for use with the PCI-7041 (SDRAM):
4 MB × 64 SO-DIMMs—10 ns, 1.05 in. max
• 32 MB
8 MB × 64 SO-DIMMs—10 ns, 1.05 in. max
• 64 MB
16 MB × 64 SO-DIMMs—10 ns, 1.05 in. max
• 128 MB
One PCI slot
One I/O window on computer
back rail
A-3
Appendix A Specifications
PCI-7041 User Manual