Troubleshooting; On-Screen Messages - ViewSonic PJ650 User Manual

Troubleshooting

On-screen Messages

When the unit's power is ON, messages such as those shown below may be displayed. When any such
message is displayed on the screen, please respond as described below.
Message
TO MAXIMIZE PERFORMANCE,
LAMP REPLACEMENT IS RECOM-
MENDED.
CLEAN THE AIR FILTER
AFTER CLEANING AIR FILTER,
RESET THE FILTER TIMER.
NO INPUT IS DETECTED
ON ***
SYNC IS OUT OF RANGE
ON ***
CHECK THE AIR FLOW
35 ViewSonic PJ650
The unit does not display a warning message on the screen when
the lamp expires or fails. When the lamp does not light, this indi-
cates that the lamp is no longer functional and should be replaced.
Replace the lamp and do not forget to reset the timer.
A note of precaution when cleaning the air filter.
After cleaning the filter, operate FILTER TIME of the OPTION Menu,
then perform reset of the filter timer.
There is no input signal.
Check the signal input connection and the status of the signal
source.
The horizontal or vertical frequencies of the inputted signal is out-
side of the operating range limits of this unit. Please confirm the
specs for this unit or the signal source specs.
The internal temperature is rising. Please turn the power OFF, then
allow the unit to cool down for approximately 20 minutes. After hav-
ing confirmed the following items, then please reset the power to
ON.
• Is there blockage of the air filter?
• Is the air filter dirty?
• Does the ambient temperature exceeds 35°C?
Description