Device In The Flex Bay - Lenovo ThinkStation P330 User Manual

a. Open the retaining clips of the memory slot.
Figure 40. Opening the retaining clips
b. Position the new memory module over the memory slot. Ensure that the notch
module is aligned with the key
the retaining clips completely close.
Note: Do not touch the circuit board of the memory module.
Figure 41. Installing a memory module
7. Reinstall any PCIe cards if you have removed them.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 89.

Device in the flex bay

Attention: Do not open your computer or attempt any repair before reading and understanding the
Appendix A "Important safety information" on page 97.
Some computer models come with a flex bay. Depending on your computer model, one of the following
devices might be installed in the flex bay:
• Flex module
• Flex storage enclosure
2 in the slot. Push the memory module straight down into the slot until
1
on the memory
.
Chapter 6 Hardware removal and installation
45