Advertisement
BEFORE FIRST USE
Fill to max, boil, discard the water, then rinse. Do this twice to remove any manufacturing dust,
etc.
FILLING
1. Remove the lid.
2. Fill with at least 1 cup of water, but not above max.
3. If you want only 1, 2, or 3 cups of water, fill to the 1, 2, or 3 marks inside the kettle.
4. Refit the lid.
USING YOUR KETTLE
1. Put the stand on a stable, level surface. Wind excess cable beneath the stand.
2. Plug the stand into the wall socket.
3. Put the kettle on the stand.
4. Move the switch to I. The light will come on and the kettle will start to heat.
5. When it boils, the kettle will switch off.
6. To switch off manually, move the switch to O, or simply lift the kettle off the stand.
GENERAL
Note: When you lift your kettle, you may see moisture on the stand. This is normal and is caused
by the steam used to switch your kettle off automatically.
BOIL DRY PROTECTION
If your kettle boils dry, a safety cut-out device will automatically switch it off. If this happens,
unplug your kettle and allow it to cool down until the cut-out resets itself. Allowing your kettle
to boil dry will shorten the life of the element.
CARE AND MAINTENANCE
1. Unplug the stand, and let the kettle cool before cleaning.
2. Wipe all surfaces with a clean damp cloth.
3. Keep the connectors dry.
4. Open the lid.
5. Squeeze the top of the filter to release it from inside the rim of the kettle, then lift it out of
the kettle.
6. Rinse the filter under a running tap while brushing with a soft brush.
7. Fit the bottom of the filter into the seam between the floor of the kettle and the wall.
8. Locate the filter in the rear of the spout.
9. Squeeze the top of the filter, then fit it under the rim of the kettle.
10. Close the lid.
4
Advertisement
