Battery Safety Warnings; Residual Risks - Ryobi ERGO Original Instructions Manual

rechargeable).
The recommended
temperature range for the charging
system during charging is between
10°C and 38°C.

BATTERY SAFETY WARNINGS

Li-ion
Do not dispose of used battery packs
in the household refuse or by burning
them. To ensure proper disposal of
waste battery packs and protect the
environment, hand over old battery
packs to your RYOBI distributor.
Segregate electronic waste properly
by removing integrated battery packs
from the main unit before disposal.
Hand them over to applicable collection
points.
To remove the integrated battery pack:
Separate the housing shells from
one another by removing the screws.
Disconnect the battery pack from the
circuit and remove.
NOTE: When opened, the product is
no longer reusable or serviceable and
should be disposed of properly.
Before removing the battery pack
from the power tool, switch on the
product until the battery pack is fully
discharged.
Ensure that the battery pack to be
disposed of cannot come in contact
with batteries, other battery packs,
or conductive materials by protecting
exposed connectors with insulating,
non-conductive caps or tape.
Never charge a damaged battery pack.
Ambient temperature range for battery
during use is between 0°C and 40°C.
ambient Ambient temperature range for battery
storage is between 0°C and 20°C.
ADDITIONAL BATTERY SAFETY
WARNINGS
short circuit, never immerse your tool,
certain industrial chemicals, and bleach
or bleach-containing products, etc., can
cause a short circuit.

RESIDUAL RISKS

Even when the product is used as
prescribed, it is still impossible to
completely eliminate certain residual
risk factors. The following hazards may
arise and the operator should pay special
attention to avoid the following:
Damage to hearing caused by noise
Wear suitable hearing protection and
limit exposure.
Wear protective eye shields or goggles
when using the product.
Limit exposure. Follow the instructions
in Risk Reduction.
Electric shock caused by contact with
hidden wires
Hold the product only by insulated
surfaces.
Dust created by operating the product
appropriate dust control mask with
WARNING
5