Sharp SJG2351FS Operation Manual & Installation Instructions page 10

INSTALLATION INSTRUCTIONS
CONNECTING THE WATER LINE
TO A DRINKABLE WATER SOURCE
If your water line is NOT drinkable, please add an external
water filter.
If you must repair or disassemble the water line, cut off the
plastic tubing to make sure you get a snug, leak-free connection.
INSTALLING DOOR HANDLES
Precautions shall be taken to prevent fall of the handle from
causing any personal injury.
List of tools to be provided by the user
Phillips screwdriver
Inner hexagon spanner
INSTALLATION PROCEDURES
1. Take out bolt 1 from accessory bag, then use Phillips
screwdriver to fix the bolt 1 into the bolt hole 2 of
refrigerator doors. See Figure 8.
2. Put the handle on the door through the bolt 1 and make sure
the handle contact the door surface closely. See Figure 9.
3. Fix the handle by rotating the handle screw 3 to the end, then
to shake the handle for verifying if it already be fixed tightly.
4. Put the cap 4 on the handle screw hole to complete this
installation.
Figure 8
Notes:
1 Bolt
2 Bolt hole
BEFORE USING THE REFRIGERATOR
• Before use, remove all packing materials, including bottom
cushions, foam pads and tapes inside of the refrigerator; tear
off the protective film on the doors and the refrigerator body.
• Before turning the refrigerator on, keep the refrigerator still
for two hours before connecting it to power supply.
• Before putting any fresh or frozen foods, the refrigerator shall
have run for 2-3 hours, or for above 4 hours in summer when
the ambient temperature is high.
10
Figure 9
3 Handle screw
4 Screw hole cap