Page 1
SOLOS Advanced Standing Desk User Manual SKU: SD-C147 Accessory list Attention: The drawings below are for guidance only and they may differ slightly from the product and fittings received. Please contact our customer service department should you have any queries.
Page 2
STEP 1 Install the Side Brackets 0.16"x0.16" Attach the side brackets(5) to the ends of the supporting beam (4) using screws(A) as show with the Allen Key(F). STEP 2 Install the Lifting Columns 0.16"x0.16" Insert the lifting columns (2) into the ends of the supporting beam(4). Fix the lifting columns using screws(D) with the Allen Key(F).
Page 3
STEP 4 Loosen Install the Tabletop 0.16"x0.16" Adjust The expansion distance of the Tighten supporting beam can be adjusted according to the actual use. Attention: When the supporting beam is greater than 1720mm, the installation method is as follows: Method 2 in Step 6. STEP 5 Install the Control Panel Power port...
Page 4
Method 2 Install the cable management tray as Method 1, Step 6. 0.16"x0.16" When the supporting beam stretches over 1720 mm, the cable management tray needs to be mounted on the middle of the supporting beam. Do not stretch the support beam beyond this hole Attent Common fault treatment...
Need help?
Do you have a question about the SD-C147 and is the answer not in the manual?
Questions and answers