Table of Contents
Advertisement
TOYOTA SAFETY SENSE
PCS PEDESTRIAN DETECTION
Under certain conditions, the PCS system included with the TSS-P package may
also help to detect a pedestrian in front of your vehicle using the in-vehicle camera
and front grille-mounted radar. The in-vehicle camera of PCS detects a potential
pedestrian based on size, profile, and motion of the detected pedestrian. However,
a pedestrian may not be detected depending on the conditions, including the
surrounding brightness and the motion, posture, size, and angle of the potential
detected pedestrian, preventing the system from operating or engaging.
As part of the Pre-Collision System, this function is also designed to first provide an
alert and then automatic braking if needed.
Refer to the Toyota Owner's Manual for additional limitations and information.
CHANGING PCS ALERT TIMING
(1) Press "
" switches and select
(2) Press "
" switches and select
setting screen is displayed.
(3) Press "
" each time to change the setting. Each time it is pressed, the
response to the PCS alert timing changes as shown above. You can press "
go back to the menu.
Note: PCS is enabled each time the engine switch is turned to Ignition On.
The system can be disabled/enabled and the alert timing of the system can be
changed. (Alert timing only, brake operation remains the same).
™
Monocular camera sensor
from the Multi-Information Display (MID).
from the MID and then press "
34
Far
Middle
(default)
Near
Millimeter
wave radar
". The
" to
Advertisement
Table of Contents
