Seav R 2295 Series Quick Start Manual

Rs485

Advertisement

RXX 2295
R
ADIO
Radio Receiver available in various work frequencies, used with the receiver BeSafe RX New.
I
I
MPORTANT FOR THE
NSTALLER
- The device must be powered by a low voltage source security that complies with EN61558-2-6.
- All operations, which require the opening of the case (installation, programming and repair, etc.), must be carried out
by experienced staff.
- The fixing of power cables and connection cables must be guaranteed by assembling cable glands supplied optional.
- Secure the plastic cover of the device to a wall inserting the mounting screws in the provided spaces.
I
MPORTANT FOR THE USER
- The device can be used by children over the age of 8 years or people with limited psychological or physical abilities or
with little knowledge and experience only when supervised or trained on the operation and how to use safely to
understand the dangers involved in its use.
- These instructions are available on the website www.seav.com
- Do not allow children to play with the device and keep the radio controls out of their reach.
- Frequently examine the plant to detect any signs of damage. Do not use the device if you need a repair.
- Always remember to turn off the power before cleaning or maintenance works.
- The cleaning and maintenance works shall not be made by children without being supervised.
ATTENTION: keep this instruction manual and respect the important safety instructions contained inside. The non-
compliance with the prescriptions may cause damages and serious accidents
Comply with the requirements of the rules
T
C
ECHNICAL
HARACTERISTICS
- Supply:
- Max consumption:
- Cable length:
- Work Frequency : RXS 2295
- Work Frequency : RES 2295 " Narrow band "
- Work Frequency : RXH 2295 " Narrow band "
- Transmitters op. :
- Range in free space :
- Working temperature:
- Dimensions:
R
RS 485
ECEIVER
Radio Receiver RXS 2295 – RES 2295 – RXH 2295
100 mt. Max.
433,92 MHz
433,92 MHz
868,30 MHz
12-18-32 Bit o Rolling Code
-10°C ÷ +55°C
53x82x40mm
GB
R&TTE 99//EC, EMC 2004/108/EC, LVD 2006/95/EC.
12Vdc
20 mA
50-100mt.
1
Rev. 1.2 26/06/2015

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the R 2295 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Seav R 2295 Series

  • Page 1 - These instructions are available on the website www.seav.com - Do not allow children to play with the device and keep the radio controls out of their reach.
  • Page 2 RX N ONNECTING TO THE ECEIVER It is possible to connect to every single BeSafe RX New receiver up to 2 Radio Receivers RXX2295. By dip switch SW1 in advance you must assign to each Radio Receiver RXX2295 its own address: DDRESS DDRESS The communication is via standard RS485.
  • Page 3 RXX2295 ODE OF OPERATION OF ADIO ECEIVER The Radio Receiver RXX2295 has two signal Led s green “ PASS “ and red“ FAIL “ and a Buzzer for the various modes of opera- tion. By radiocommand you can just send the code you want and the Radio Receiver RXX2295 will emit a loud signal sound and at the same time the green Led will turn on if the Radiocommand was already stored into the Receiver BeSafe RX New, otherwise the red Led will turn on.

This manual is also suitable for:

Rxs 2295Res 2295Rxh 2295

Table of Contents