Saving1 Program Data On Tape - Korg DW-8000 Owner's Manual

TAPE INTERFACE
2.saving Program Data on Tape _ _ _
■ Follow
the procedures below to write DW-8000 program memory contents to your connected tape record•
er.
[iJ
Connect the DW-8000 rear panel TO TAPE jack to
the microphone (mic) input jack on the tape recorder.
You rmay need a plug adaptor or special connection
cord if the input jack is not the usual "mini jack" size.
!?l
Set the DW-8000 rear panel TAPE switch to the EN-
ABLE (ENA) position.
@J
Prepare the tape recorder for recording. Begin re-
cording and let the tape advance until it is past the
leader tape (at the beginning of the cassettef.
@ :! Press the recorder's pause key at the point from
which you will begin recording data.
At this point, the DW-8000 is sending out
a
test tone
as a reference for setting recording level {input level)
on the tape recorder. Adjust the tape recorder's re-
cording level as you would normally (refer to tape re-
corder's instruction manual).
~
After setting recording level, release the pause key so
that the recorder begins recording.
[!?] Press the SAVE key on the OW-8000.
44
The DW-8000 will start sending data and the DIS-
PLAY will appear as shown here.
The D!Sf>LAY will now a,ppear as shown here.
TAPE
ENABLE DISABLE
7
r
li!u
,
g
SAVE
.,.
.. .
·'.
PROGRAM NO
VALUE
PARAMETER NO
-
P ARAMETER NO
fois
s11ows
the
bank number (len
digit
of program nomber}
1-8
during
dc1la output.