Korg DW-8000 Owner's Manual page 56

MIDI
- CHANNEL
This parameter is used to select a channel for data send
and receive. The same channel must be specified for
sending and receiv ing data. (Different channels cannot
be selected independently for send and receive.) At
power-ON, the data send/receive channel is set for that
previously selected .
• ENABLE
This selects which kinds of received MIDI data the
DW-8000 will send and receive. At value 1 (NOTE
DATA), the DW-8000 sends and receives only "note
data." At value 2 (All), it sends and receives all MIDI
data specified in the DW-8000 MIDI specifications (im-
plementation notes.)
For example, if you don't want program numbers to be
changed by some external device through MIDI , then
set this value to
1.
The most recently selected ENABLE value is retained
when power is turned on and off.
-OMNI
Omni mode ON (value 1) is selected by default when the
power is turned on. When Omni mode is on, the DW-
8000 receives MIDI data on all channels (regardless of
the parameter 84 setting). However, Omni mode can
also be turned on and off from the controlling (sending)
device. When Omni mode is off, then the DW-8000 re-
ceives MIDI data sent only on the MIDI channel speci-
fied
by
parameter
84.
- ARP CLOCK (Arpeggio clock)
■ Determines whether the Arpeggiator is operated by
the DW-8000' s internal clock or it is operated by the
signals, including timing clock, start, and stop, sent
from external MIDI equipment. This par.ameter is also
used for rough adjustment of arpeggio speed.
56
VALUE
f
I
1
:o
VALUE
2
VALUE
n
u
DATA SEND/RECEIVE CHANNEL
CH-1
1
CH-16
Kind of Data Sent/Received
(NOTE DATA)
NOTE ON/NOTE OFF
(ALL)
All data
OMNI MODE
OFF
ON