F18 HOTAS INSTALL GUIDE EN V1.1 1 Packing Diagram ......................... 1 A Side ........................2 1.2 B Side ........................3 1.3 C Side ........................3 1.4 D Side ........................4 1.5 E Side ........................4 2 F18 Throttle Installation ....................... 5 2.1 F18 throttle L/R Handles Installation ................
2 F18 Throttle Installation 2.1 F18 throttle L/R Handles Installation 1. L/R throttle handles need connected to the aviation plug. 2. Install the gasket between the grip and the throttle arm. It is also possible not to install this accessory on demand.
2.2 Throttle desk mount Installation 3. Insert the assembled desk mount into the throttle base. (When assembling, always ensure that the two round tubes are inside),Install and tighten the screws(8PCS) ① 4 of M8 35mm type Allen screws ② 8 of M8 type Screw washer ③...
Page 8
4. Insert the fixing plate and fix it with screws.(4PCS) ① 8 of M8 40mm-type Allen screws...
② 4 of M8 type Screw washer ③ 12 of Nylon Screw washer M8 ④ 4 of M8 type locknuts 2.3 How to install on table with desk mount 1. The top of the desk mount depends on the surface of the table. 2.
3.1 Install Joystick base with desk mount 1. fix the plate with desk mount holder ① 4 of M6 30mm-type Allen screws ② 8 of M8 type Screw washer 2. Connect the desk mount holder to the connection tube. ① 4 of M6 35mm-type Allen screws ②...
3.2 Multi ways to install the joystick with base and add on J1-base+extension J1-base+extension J1-base+Z axis J1-base +Jgrip rod+Z axis kit+Jgrip rod+Jgrip kit+Jgrip...
3.3 F18 joystick and base Installation 1. Insert the PS2 connector. 2. Turn the knurled cover counterclockwise (Only twist the knurled cover during disassembly and assembly, otherwise the wiring will be damaged). 3. Use a screwdriver to tighten the knurled cover clockwise. Note: The connection steps of other components are the same, and the operation steps are reversed when disassembling.
3.4 How to install on table with desk mount 1. The top of the desk mount depends on the surface of the table. 2. Hold the end of the unit with your hand to ensure that the device is in the position shown. 3.
Need help?
Do you have a question about the F18 HOTAS and is the answer not in the manual?
Questions and answers