SanRex SANARG 180AP Operator's Manual page 17

OPERATION
Overview
The key feature of the control panel is the logical way in which the controls are arranged. All the main
parameters needed for day-to-day working can easily be
-selected with the keys
-altered with the adjusting dial
-shown on the display during welding.
The illustration below shows an overview of the main settings needed for day-to-day working, using the
SANARG 180AP control panel as an example. You will find a detailed description of these settings in
the following section.
(1) AC/DC selecting key
(2) Mode selecting key
(4) Power/ Alarm indicator
Light up if the power switch on
Light up if the welder overheat, over-voltage or over-current. At the same time, display Err 001.
(5) Welding current adjust
Before the start of welding, you can use this potentiometer adjust welding current
(6) Welding current display
Display the pre-set or the actual welding current value.
Before the start of welding, it shows the pre-set current value
After the start of welding, it shows the present actual value of the welding current.
(7) Adjusting dial
If the parameter indicator lights up, then the selected parameter can be altered on adjusting dial.
15