E-Lock - Lenovo ThinkStation P330 User Manual

c. Align the four holes on the rear of the storage drive cage with the corresponding hooks in the drive
bay assembly. Then slide the storage drive cage downward until it snaps into position. Install the
screw to secure the storage drive cage.
Figure 55. Installing the storage drive cage
d. Connect the signal cable and the power cable to the new storage drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 59.

E-lock

Attention: Do not open your computer or attempt any repair before reading and understanding the
Appendix A "Important safety information" on page 67.
Note: To remove the screws, you need a special tool (T15 star wrench).
To remove or install the E-lock, do the following:
1. Remove the computer cover. See "Preparing your computer" on page 24.
2. Locate the E-lock.
3. To remove the E-lock, do the following:
a. Disconnect the E-lock cable from the E-lock connector on the system board.
58
P330 User Guide